Color Coated Corrugated EPS Roof Sandwich Panel for Office Building
Product Description
Modular EPS sandwich panel:
Eps sandwich panel with three layers, the top& bottom layers are colored steel plates, and the core layer of polystyrene foam is formed by high pressure composite of German vacuum technology. The surface of the sandwich panel is smooth and clean, and the dirt can be easily removed. It has good chemical stability to the atmosphere, water and general concentration of acid, alkali, salt and other media. It has high surface finish, excellent gloss retention, no discoloration, corrosion resistance and protection. Light and anti-aging.
Application: insulation/dry trucks, large-span structural roofs, wall surfaces, thermal insulation (or fireproof) plants, clean room, cold room, high-end combination houses, container houses, etc.
Roofing polystyrene conposite panel model type:
EPS sandwich panel specification:
| Panel effective width: | 950 mm |
| Steel sheet thickness: | 0.30 ~ 0.70 mm |
| Panel thickness: | 50/75/100/150/200/250 mm |
| EPS density: | 8 ~ 20 KG/M⊃3; |
| Color: | As per RAL or customized |
| Coating: | PE, SMP, HDP, PVDF. |
| Steel type: | PPGL, PPGI steel / Aluminum sheet / Stainless steel sheets |
| Length limitation: | Max 5.9m for 20FT; |
| Max 11.9m for 40FT. | |
| Installation accessories: | Aluminum U channels,self screws, flashings, etc. |
EPS sandwich panel features:
Heat& thermal insulation,
Light weight with high strength,
Available colors: white, sea blue, grey, red, orange, yellow,green, purple, black, etc. or can be customized.
Long life,
Waterproof,
Sound insulation,
Favorable price,
Easy to install.
Other notes:
1)After the materials arrive at site,please check the quantity of each item carefully and see if any transport damage happened,according to the delivery list. If you found out any missing or panel damage,please check if it is indicated on the invoice or not,also immediately notify the relevant service department of Yumi steel.
2)The small piece of material,for example fasteners,connecting pieces and sealants should be placed in safe place,it’s better to be locked,in case of theft.
3)Please don’t use the dirty gloves to handle and install wall panels and edge trims(flashings),especially galvalume material and edge trims,in order to avoid the dirty appeared on wall panels and edge trims surface,and it’s hard to clear and will have effects on aesthetic.
4)All the parts that need sealants should wipe the attachment surface clean,to make sure there is good adhesion on color steel.The glue joint should be full and dense to avoid water leakage.
5)The PVC films on panels,please peel it off within 3 ~ 4 months,after shipment.Otherwise it will have chemical reaction and make it very difficult to peel off.
6)During the installation process, wall panel maybe damaged by collision and friction with the scaffold, column, brick wall,etc.So please be careful about this point.
7)During the on-site cutting process of wall panel, the bottom surface of the cutting machine should not be in direct contact with the color steel surface.It’s best padded with thin plywood on the panel,then cut.The burrs on the cutting end need to be removed and installed in time.
8)Iron scraps are generated after cutting and drilling holes,and these iron filings on panel surface need to be cleaned.These iron scraps must be cleaned up in time and must not be left overnight.Iron filings can rust in a humid environment. The rust spots are verified to be removed after the surface of the board is formed, and the paint surface or even the substrate may be damaged for a long time.Similarly, other cut-off color steel heads, iron bars pulled by aluminum alloy steel nails, etc. should be cleaned up in time.
9)After the daily installation work is completed, all the debris left on the site must be cleaned up.